Item reference UCPE - 5482 added to list

Click on the + to the right of any item to add it to your list

Mixers

Continuous

UCPE-6218

Stainless steel continuous mixing screw with adjustable paddles. The trough is 370mm wide and working length 2.9 metres. It has a side mounted drive and a spray bar with nozzles across the top for the addition of liquids.
This unit can be used for mixing a number of friable solids with or without liquids. Done very little work.
This one was used for adding moisture, hence weight, to dry grain following a dry harvest.

Price - £8,000

+

Ribbon Blade

UCPE-5482

Stainless steel lined cylindrical horizontal mixer with inclined blades on a central shaft. Product to be mixed is introduced via an angled duct in the end plate. There is a 45kw SEW Eurodrive gearmotor and gearbox but not attached to the mixer. Output speed is 47 rpm. The gearbox output shaft was cut through during removal. The mixer body has two flanged outlets at base level. The body is 1.2 metres diameter x 3.66 metres long giving a total volume of 6 M3 ( working volume may be smaller). There are two large access doors in one side with safety switches.

Price - £7,000

+

UCPE-6155

Horizontal ribbon mixer 3.96M long inside x 1.53M wide inside giving a working volume of about 8m3. The mixer has a 22kw underslung geared motor with triplex chain drive. There are 2 No 400mm x 400mm electro pnuematic discharge slides on the mixer bottom. The mixer is on a support frame with a set of 4 No load cells to record the weight of the different ingredients as they are added. The overall dimensions of the mixer with drive and supporting steelwork is about 6M long x 1.7M wide x 3.3M high. Weight display and weight preset controls can be included but may not be in working order.

Price - £9,000

+

Vertical

UCPE-6104

Skjold vertical mixer with a nominal 1 tonne capacity and an above floor additives feed hopper.

Price - £750

+

UCPE-6215

Vertical mixer being used as a live bin for bagging meal. It has no bottom infeed hopper so would have to be top fed if used as a mixer. It is 1.3M diameter x 3.3M high + about 200mm more for top drive pulley and belts from the side mounted drive motor. The mixer has a working volume of about 2m3.

Price - £1,500

+